FoxGate S6424-S2C2 series User Manual

ACL Configuring
118
Config ACL subitem successfully.
If it is the configuration mode, sub-item 0 is the first command. You can see as below
configuration:
Switch(config)#show access-list config 1
Standard IP Access List 1, match-order is config, 2 rule:
0 deny any
1 permit 1.1.1.1 0.0.0.0
If it is the auto mode, sub-item 0 is the longest ACL match rule. You can see as below
configuration:
Switch(config)#show access-list config 1
Standard IP Access List 1, match-order is auto, 2 rule:
0 permit 1.1.1.1 0.0.0.0
1 deny any
Notes, ACL must enable. Switches must obey “first enable then active. Please refer to
Chapter 1.6 for detailed configuration.
18.1.2 Switch Support ACL
Switch support ACL as below:
Basic ACL
Extended ACL
Layer 2 AC
18.2 Configuring Time Range
There are two kinds of configuration: configure absolute time range and periodic time
range. Configuring absolute is in the form of year, month, date, hour and minute. Configuring
periodic time range is in the form of day of week, hour and minute.

FoxGate S6424-S2C2 series Specifications

General

Brand	FoxGate
Model	S6424-S2C2 series
Category	Switch
Language	English