EasyManuals Logo

FoxGate S6424-S2C2 series User Manual

FoxGate S6424-S2C2 series
286 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #155 background imageLoading...
Page #155 background image
STP Configuration
155
#Configure cost of Ethernet0/0/1 and Ethernet0/0/2 to be 10 to make sure link between
S-switch-B and S-switch-C to be main link
S-switch-C(config)#interface range ethernet 0/0/1 ethernet 0/0/2
S-switch-C(config-if-range)#spanning-tree cost 10
S-switch-C(config-if-range)#exit
# Enable global RSTP
S-switch-C(config)#spanning-tree
Check the configuration
# S-switch-A
S-switch-A(config)#show spanning-tree interface ethernet 0/0/1 ethernet 0/0/2
The bridge is executing the IEEE Rapid Spanning Tree protocol
The bridge has priority 0, MAC address: 000a.5a13.b13d
Configured Hello Time 2 second(s), Max Age 20 second(s),
Forward Delay 15 second(s)
Root Bridge has priority 0, MAC address 000a.5a13.b13d
Path cost to root bridge is 0
Stp top change 3 times
Port e0/0/1 of bridge is Forwarding
Spanning tree protocol is enabled
remote loop detect is disabled
The port is a DesignatedPort
Port path cost 200000
Port priority 128
root guard enabled and port is not in root-inconsistent state
Designated bridge has priority 0, MAC address 000a.5a13.b13d
The Port is a non-edge port
Connected to a point-to-point LAN segment
Maximum transmission limit is 3 BPDUs per hello time
Times: Hello Time 2 second(s), Max Age 20 second(s)
Forward Delay 15 second(s), Message Age 0
sent BPDU: 54
TCN: 0, RST: 54, Config BPDU: 0

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the FoxGate S6424-S2C2 series and is the answer not in the manual?

FoxGate S6424-S2C2 series Specifications

General IconGeneral
BrandFoxGate
ModelS6424-S2C2 series
CategorySwitch
LanguageEnglish

Related product manuals