EasyManuals Logo

FoxGate S6424-S2C2 series User Manual

FoxGate S6424-S2C2 series
286 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #75 background imageLoading...
Page #75 background image
GVRP Configuration
75
Switch(config)#gvrp
Turn on GVRP successfully.
Switch(config)#garp permit vlan 2,3,4
Switch(config)#interface e 0/0/1
Switch(config-if-ethernet-0/0/1)#gvrp
Switch(config-if-ethernet-0/0/1)#exit
Verify GVRP configuration
Switch(config)#show gvrp
GVRP state : enable
Switch(config)#show gvrp interface ethernet 0/0/1
port GVRP status
e0/0/1 enable
Total entries: 1.
Switch(config)#show garp permit vlan
VLAN 1 is Garp default permit VLAN
Other Garp permit VLAN : 2-4
***************************************************************
Configure S2
***************************************************************
Preparation before configure
Switch(config)#vlan 5,6
Switch(config-if-vlan)#switchport ethernet 0/0/2
Add VLAN port successfully.
Switch(config-if-vlan)#switchport ethernet 0/0/3
Add VLAN port successfully.
Switch(config-if-vlan)#exit
Switch(config)#interface range ethernet 0/0/2 to ethernet 0/0/3
Switch(config-if-range)# switchport mode trunk
Switch(config-if-range)#exit
Configure GVRP
Switch(config)#gvrp
Turn on GVRP successfully
Switch(config)#interface range ethernet 0/0/2 to ethernet 0/0/3
Switch(config-if-range)#gvrp.
Switch(config)#garp permit vlan 5,6
Verify GVRP configuration

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the FoxGate S6424-S2C2 series and is the answer not in the manual?

FoxGate S6424-S2C2 series Specifications

General IconGeneral
BrandFoxGate
ModelS6424-S2C2 series
CategorySwitch
LanguageEnglish

Related product manuals