EasyManuals Logo

FoxGate S6424-S2C2 series User Manual

FoxGate S6424-S2C2 series
286 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #94 background imageLoading...
Page #94 background image
IGMP Snooping
94
1. Network requirements
As shown in the figure 1-1,Host-A, Host-B, Host-C hosts separately belong to VLAN2,
VLAN3, VLAN4.Three hosts separately receive the data of the multicast address 224.0.1.1~
224.0.1.3 per configuring.
2. Configuration steps
Configuring S-switch-A
#Configure VLAN2 to 4,and add the ports separately into VlAN2,3,4 of Ethernet0/0/1,
Ethernet0/0/2 and Ethernet0/0/3.
S-switch-A(config)#vlan 2
S-switch-A(config-if-vlan)#switchport ethernet 0/0/1
S-switch-A(config-if-vlan)#exit
S-switch-A(config)#vlan 3
S-switch-A(config-if-vlan)#switchport ethernet 0/0/2
S-switch-A(config-if-vlan)#exit
S-switch-A(config)#vlan 4
S-switch-A(config-if-vlan)#switchport ethernet 0/0/3
S-switch-A(config-if-vlan)#exit
#Enable igmp snooping
S-switch-A(config)#igmp-snooping
When Host-A, Host-B, Host-C forward IGMP report to S-switch-A,S-switch-A will learn
corresponding multicast table entry port ;When the Multicast Source Router send igmp query
time to the S-switch-A message, S-switch-A will learn the appropriate router port entry.
Show the switch learned multicast group
S-switch-A(config)#show multicast
show multicast table information
MAC Address : 01:00:5e:00:01:01
VLAN ID : 2
Static port list :.
IGMP port list : e0/0/1
Dynamic port list :
MAC Address : 01:00:5e:00:01:02
VLAN ID : 3
Static port list :.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the FoxGate S6424-S2C2 series and is the answer not in the manual?

FoxGate S6424-S2C2 series Specifications

General IconGeneral
BrandFoxGate
ModelS6424-S2C2 series
CategorySwitch
LanguageEnglish

Related product manuals