2 Environment Settings
52
Environment Settings
2
-Trap to be Received:
You can set whether to send notification of [Print], [Cold Start], and [Authentication
Failure] events.
z
Add UDP IPv6 Address button
You can add a recipient address for UDP IPv6 trap notification by pressing this button.
- IP Address:
You can enter the IP address for entry.
-UDP Port Number:
You can set the UDP port No. for entry (a value between 1 and 65535).
-SNMP Version:
You can specify the SNMP version for entry as [v1] or [v2c]. (Default: SNMP v1)
- Trap Community Name:
You can enter the trap community name for entry (between 1 and 32 ASCII code
characters). (Default: SNMP_trap)
-Trap to be Received:
You can set whether to send notification of [Print], [Cold Start], and [Authentication
Failure] events.
z
Delete button
You can delete the traps specified for the trap notification recipient IP address by
pressing this button.
z
Edit button
You can display notification information of the trap you are using. You can specify the
events for which to send notification.
îš„ Apply button
You can apply changes by pressing this button.
Note • Reboot the machine to enable new settings.
Microsoft Networking (Connectivity > Protocols)
You can set the SMB protocol and WINS server.
îš„ Filing Destination
z
SMB Port Status
You can check [Enabled] to use SMB. (Default: On)
z
Physical Connection
[Ethernet] is displayed.
z
Transport
[TCP/IP] is displayed.
îš„ Server Information (WINS Server)
Note • Displays when [IP Mode] is set to [IPv4] or [Dual Stack].
z
Protocol
Displays [Enabled].
z
Obtain WINS Server Address Automatically
You can check this checkbox to acquire the WINS server address automatically using
DHCP. When you set the WINS server address acquisition method to DHCP, you must also
set the IP address acquisition method to [DHCP]. (Default: ON)
To Next Page
Loading...
Need help?
General
