Interface Cables
21
Before Using the Machine
1
Interface Cables
When you connect the machine directly to your computer, use the USB interface.
When you connect the machine to a network, use the Ethernet interface.
Using the USB Interface
This section describes the installation procedures for the USB interface.
z
The USB interface of the machine supports USB 3.0.
1
Press the push-button power switch to switch off the power.
2
Make sure that the touc
h screen is blank
and the <Power Saver> button is not lit.
3
Open the front cover.
4
Press the main power switch to the [ ] position to switch off the main power.
5
Remove the rear right cover.
6
Connect the USB cable to the interface connector.
To Next Page
Loading...
