Printer Environment Settings
380
Printer Environment Settings
7
3
Set an IP address and the other addresses.
Skip this step if an IP address is already set.
If DHCP or BOOTP is available in your environment, configure the method for obtaining the
address. The configuration of an IP address, a subnet mask, and a gateway address is not
required.
z
For information on how to set an IP address, refer to "Protocol Settings" (P.239).
4
Enable the Bonjour port, and the Discovery feature that automatically detects printers on
the IP network can be enabled.
z
To print from a printer detected by Bonjour, the LPD port must be enabled in advance.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [Bonjour], and then select [Change Settings].
4) Select [Port Status], and then select [Change Settings].
5) Select [Enabled], and then select [Save].
5
Select [Close] repeatedly until the [Tools] screen is displayed.
6
Select [Close].
z
Rebooting the machine may be required depending on the settings. When a message displayed on the
screen, follow the message and reboot the machine.
7
Print a configuration report to confirm that the LPD port is enabled and that TCP/IP is set
up correctly.
z
For information on how to print a configuration report, refer to "Print Reports" (P.131).
8
Configure other LPD or Port9100 settings as necessary.
z
For information on how to set up the LPD port or Port9100, refer to "CentreWare Internet Services Setting Items" (P.381).
Step 3 Configuration on the Computer
To print from the machine, you need to install a print driver on your computer.
z
For information on the supported operating systems, refer to "Supported Operating Systems" (P.375).
z
For information on the driver installation procedures, refer to the Media Information contained in the Media
(Software/Product Manual).
z
You can print via TCP/IP (LPD) from a Macintosh computer for Mac OS X. For information on the installation
procedures of the print driver for Mac OS X, refer to the manual for Mac contained in the Media provided with
the driver.
z
For information on the installation procedures of Adobe PostScript 3 Kit (optional), refer to the manual for
Mac contained in the media provided with the driver.
To Next Page
Loading...
Need help?
General
