Maintenance
90
Maintenance
3
Replacing Staple Cartridge (for Finisher A2)
When the optional Finisher A2 is installed and the staple cartridge needs to be replaced, a
message appears on the touch screen. When this message appears, load a new staple case
into the staple cartridge.
z
The use of staple cartridges not recommended by Fuji Xerox may degrade quality and performance. Use only
staple cartridges recommended by Fuji Xerox.
z
When the machine is in the Power Saver mode, exit the Power Saver mode by pressing the <Power Saver>
button and the <Machine Status> button on the control panel before you replace the staple cartridge.
z
When replacing the staple cartridge, press the <Machine Status> button and check the current status for the
staple cartridge even when the control panel is lit.
z
If the staple cartridge was not replaced properly, the message remains on the touch screen. Follow the
procedure and replace the staple cartridge again.
z
To order a staple cartridge, contact our Customer Support Center.
1
Make sure that the machine is not operating, and gently open the finisher front cover.
2
Take the staple cartridge out of the finisher.
z
The staple cartridge is firmly inserted. A slight force is required to pull the cartridge out of the finisher.
Message Solution
The Staple Cartridge is running out of staples.
Check the Staple Cartridge and order staples.
Prepare new staples.
z
Staples cannot be replaced yet.
The Staple Cartridge is out of staples or not fully
inserted. Check the Staple Cartridge.
Replace staples with new ones.
To Next Page
Loading...
Need help?
General
