Appendix
756
Appendix
16
Density Uniformity Adjustment (Semi Auto Process
Using Scanner)
This section describes semi auto adjustment of the density uniformity.
z
Output paper for the density uniformity adjustment is counted for the number of printed pages. For more
information, refer to "Billing Information" (P.150).
z
When using a smart card authentication system such as IC Card Gate, you may be requested authentication
before printing or scanning a calibration chart.
Density Uniformity Adjustment
You can adjust output image (density).
1
Load paper in a tray.
z
Load paper of 210 mm x 210 mm or larger.
z
If you use colored paper or paper with dark ground color, it may result in an adjustment failure.
2
Press the <Log In/Out> button, and then enter the System Administration mode.
z
For how to enter the System Administration mode, refer to "System Settings Procedure" (P.156).
3
Select [Tools] on the Services Home screen.
4
Select [System Settings] > [Common Service Settings] > [Maintenance].
5
Select [Density Uniformity Adjustment].
z
Select [ ] to return to the previous screen or [ ] to move to the next screen.
To Next Page
Loading...
