Tools
258
Tools
5
îš„ Server Name/IP Address
Enter the server name or IP address.
This setting is valid when [SMB Server Setup] is set to [By Domain & Server Names/IP
Address].
z
Use the NetBIOS computer name or full computer name with DNS suffix for the server name.
z
For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value from 0 to 255.
Security Settings
Set the security settings.
SSL/TLS Settings
Configure the SSL/TLS settings to encrypt the communication between the server or the
client computer and the machine. Enabling SSL/TLS protects the communication from an
unauthorized access and prevents information leakage or data falsification.
îš„ Device Certificate - Server
Select a certificate for HTTP SSL/TLS communications.
îš„ HTTP - SSL/TLS Communication
Select whether or not to enable HTTP SSL/TLS communications.
îš„ HTTP - SSL/TLS Port Number
Set the port number used for HTTP SSL/TLS communication from 1 to 65535.
The default value is 443.
z
Do not use the numbers assigned to the other ports.
îš„ LDAP - SSL/TLS Communication
Set whether or not to enable the SSL/TLS communications for authentication and searches.
If you enable the LDAP SSL/TLS communications, you must set [Primary Server - Port
Number] and [Secondary Server - Port Number] under [LDAP Server/Directory Service
Settings].
The port number for SSL/TLS communications of the LDAP directory server is normally set
to 636.
îš„ SMTP-SSL/TLS Communication
Configure the SSL/TLS communications.
z
The Internet Fax Direct (P2P) feature does not support SMTP-SSL/TLS communication.
îš‹
Disabled
The machine does not communicate in SSL/TLS.
îš‹
STARTTLS (If Available)
The machine verifies the certificate and communicates in SSL/TLS. If the verification fails,
the machine does not communicate in SSL/TLS.
To Next Page
Loading...
Need help?
General
