Paper and Other Media
66
Paper and Other Media
2
Changing the Paper Size
This section describes how to change the paper size in Trays 1 to 4, and 6.
z
Do not load paper of mixed sizes together into a tray.
z
The types of paper in Trays 1 to 4, and 6 are preset. Normally, Trays 1 to 4 are set to plain paper. When
changing to a different paper type, change the paper quality settings to match the type of paper to be
loaded so that you can maintain high quality printing. For more information on paper type settings, refer to
"Changing the Paper Settings" (P.73).
z
Non-standard size paper can be loaded in Trays 1 to 4. When loading non-standard size paper, you must
register the paper size. For information on registering paper sizes, refer to "Paper Size" (P.176).
z
For more information on corresponding paper sizes, refer to "Paper Size Settings" (P.203).
z
For more information on how to copy on non-standard size paper, refer to "Copy" > "Copy" > "Paper Supply
(Selecting the Paper for Copying)" in the User Guide. For more information on how to print on non-standard
size paper, refer to the help of the print driver.
Changing the Paper Size for Trays 1 to 4
The following describes how to change paper size in Trays 1 to 4.
1
Pull out the tray until it stops.
z
While the machine is processing a job, do not pull out the tray that is being used for the job.
z
To prevent paper jams or erroneous detection of loaded paper in a tray by the machine, do not add paper on
top of any remaining paper in the tray.
2
Remove any paper loaded in the tray.
3
While pinching the two paper guides, move them to the edges of the paper.
To Next Page
Loading...
Need help?
General
