Tools
310
Tools
5
5) Click [Edit]. Configure connection settings for the remote server again.
z
Enter an address beginning with "https" instead of "http" into the address box in the web browser.
6) Click [Apply]. After a short while, [Settings have been changed.] is displayed.
Server Setup
This section describes how to register a server on access web applications.
z
If there are one or more servers to register, it is helpful to assign the servers to the buttons displayed on the
Services Home screen. For information on changing the buttons on the Services Home screen, refer to
"Customizing the Control Panel" (P.32).
1
Select [Server Setup].
2
Select an access destination you want to register, and then select [Change Settings].
3
Enter the URL of the access destination, if you register an access destination in a new entry.
îš„URL
Enter the URL of the access destination with up to 256 single-byte characters, and select
[Save]. URL must begin with the type of the protocol used.
Use the version of a web application that is set [Web Applications Version] in "Web Browser
Setup" (P.313).
For example:
z
http://www.example.com
z
http://192.0.2.1 (IPv4)
z
http:// [2001:DB8::1234] (IPv6)
z
https://www.example.com
z
https://192.0.2.1 (IPv4)
z
https:// [2001:DB8::1234] (IPv6)
When you connect the server specifying the version of the web application to be used, enter
the version after the protocol type. The setting made here takes precedence of the setting
made in [Web Applications Version].
For example:
z
When specified with V2
- http-v2://www.example.com
- http-v2://192.0.2.1 (IPv4)
- http-v2://[2001:DB8::1234] (IPv6)
z
When specified with V4
- http-v4://www.example.com
- http-v4://192.0.2.1 (IPv4)
- http-v4://[2001:DB8::1234] (IPv6)
z
When specified with V5
- http-v5://www.example.com
- http-v5://192.0.2.1 (IPv4)
To Next Page
Loading...
Need help?
General
