Tools
336
Tools
5
1
Select [On].
2
Enter a 2-digit relay station ID with the numeric keypad.
z
The relay station ID is the address number for the base station (the machine) already registered on the relay
station.
3
Select [Speed Dial 001<->099].
4
Enter a speed dial number of broadcast destination (001 to 099) or group number (#01 to
#09) registered on the relay station with the numeric keypad, and then select [Add].
z
If there are more than one broadcast destinations, repeat step 4.
5
To print a document also at the relay station, under select [On] for [Print at Relay Station].
6
Select [Save].
Billing - Day Time, Billing - Night Time, Billing - Midnight
Set the connection time for one unit charge in each of the time bands (daytime/night/
midnight).
You can set a value from 0.1 to 255.9 seconds in 0.1 second increments.
z
This item is displayed when [Accounting] > [Accounting Type] is set to [Local Accounting] and [Fax/Internet Fax Service] is set to
[Enable Accounting] under [Auditron Mode]. For information on how to enable the feature, refer to "Auditron Mode" (P.346).
z
The information registered can be confirmed by printing a Billing Data List. For information about how to
print, refer to "Billing Data List" (P.138).
1
Select one of [Billing - Day Time], [Billing - Night Time], and [Billing - Midnight].
2
Select [Billing].
3
Enter the time for one unit charge from 0.1 to 255.9 seconds in 0.1 second increments with
the numeric keypad.
To Next Page
Loading...
Need help?
General
