Authentication/Security Settings
357
Tools
5
îš„ When Smart Card Reader is Connected
Set whether or not to enable user ID authentication when [Login to Local Accounts] is
selected and the smart card reader is connected.
When [Smart Card Login] is selected, user ID authentication cannot be used. When [Smart
Card or Control Panel Login] is selected, both smart card authentication and user ID
authentication can be used.
îš„ Account Auto Setup for Card Login
Set whether or not to register new user information when [Login to Local Accounts] is
selected and an unregistered user holds a card over the smart card reader.
When [Disabled] is selected, the machine does not register the user. When [Enabled] is
selected, the machine registers the user automatically.
z
When [Enabled] is selected, [User Name], [Service Access], and [Add User To Authorization Group] will be
displayed.
z
Set the user name by selecting [User Name].
z
When [Service Access] is selected, [Copy], [Fax], [Scan], and [Print] will be displayed. You can set [Feature
Access] and [Change Account Limit] for each item.
z
When [Add User To Authorization Group] is selected, you can select a user role and an authorization group for
the user.
z
When [Passcode Entry for Smart Card Login] under [Tools] > [Authentication/ Security Settings] >
[Authentication] > [Passcode Policy] is set to [On], you need to enter the passcode twice for the auto assign.
îš„ Guest User
Set whether or not to permit a guest user when [Login to Remote Accounts] is selected. Set
the guest user passcode from 4 to 12 digits.
z
Access restriction for each service cannot be specified for the guest user.
îš„ Use of Smart Card
Set whether or not to use smart card authentication.
îš„ Smart Card Link Mode
Set whether or not to require a passcode for smart card authentication when [Login to
Remote Accounts] is selected.
îš„ Smart Card Certificate Verification
Set whether or not to verify the smart cart certificate when a user uses the smart card.
When [Enabled] is selected, the owner of the smart card is verified not only by PIN code
verification but by certification verification of the smart card and private key match. In this
case, the upper level CA certificate of the smart card certification must be registered on the
machine.
When [Disabled] is selected, the owner of the smart card is verified by PIN code verification.
z
This item is displayed when the Extensible Customization Function is set to be enabled.
To Next Page
Loading...
Need help?
General
