Installation Procedures
429
Using IP Fax (SIP)
10
2
Configure VoIP gateway settings.
z
For more information on VoIP gateway registration, refer to "VoIP Gateway Setup" (P.249).
1) Select [Connectivity & Network Setup].
2) Select [SIP Settings].
3) Select [VoIP Gateway Setup], and then select [Change Settings].
4) Select a VoIP gateway to register, and then select [Change Settings].
5) Select [ID], and then select [Change Settings].
6) Specify an ID, and then select [Save].
7) Select [Gateway Address], and then select [Change Settings].
8) Specify the IP address of the VoIP gateway, and then select [Save].
9) Select [Save].
10)To configure another VoIP gateway, repeat steps 4 to 9.
11)Select [Close].
3
Select [Close] repeatedly until the [Tools] screen is displayed.
4
Select [Close].
z
Rebooting the machine may be required depending on the settings. When a message displayed on the
screen, follow the message and reboot the machine.
5
Print a configuration report to confirm the VoIP gateway settings.
z
For information on how to print a configuration report, refer to "Print Reports" (P.131).
To Next Page
Loading...
Need help?
General
