Fuji Xerox DocuCentre-VI C3371 Administrator's Guide

Problem Solving
540
Problem Solving
15
"001-001" - "004-999"
Error Code
Cause and Remedy
003-311
003-318
003-319
003-320
003-321
003-322
003-323
003-324
003-325
003-326
003-327
003-328
003-329
003-330
003-331
003-332
003-333
003-334
003-335
003-336
003-337
003-338
003-339
003-340
003-341
003-342
003-343
003-344
003-345
003-346
[Cause] An error occurred.
[Remedy] Switch off the machine power, make sure that the touch screen
is blank, and then switch on the machine power. If the same
message is displayed again, contact our Customer Support
Center.
003-700
[Cause] Too many documents are set in the document feeder after
clearing the paper jam.
[Remedy] Check the output, and then replace the documents that have
not been copied yet.
003-701
[Cause] A digital code is embedded in the document to restrict
duplication.
[Remedy] Use a document in which no digital code is embedded.
003-702
[Cause] You tried to copy sides 1 and 2 of a document simultaneously
specifying different Reduce/Enlarge ratio for each side.
[Remedy] Specify the same Reduce/Enlarge ratio for both sides.
003-703
[Cause] The Calibration Chart is not detected correctly.
[Remedy] Place the Calibration Chart properly.
003-704
[Cause] An error is found in the calibration pattern read, and the
machine may be out of order.
[Remedy] Execute the calibration again. If the error is not still resolved,
contact our Customer Support Center.

Fuji Xerox DocuCentre-VI C3371 Specifications

General

Brand	Fuji Xerox
Model	DocuCentre-VI C3371
Category	All in One Printer
Language	English