Appendix
786
Appendix
16
Extended Settings
Document size 1 Sets the client-created document size.
[99](Default): Paper
[100]: Continuous form paper (10x12")
[101]: Continuous form paper (10x11")
[102]: Continuous form paper (15x12")
[103]: Continuous form paper (15x11")
[3]: A3
[4]: A4
[5]: A5
[14]: B4
[15]: B5
[21]: 8.5x14"
[22]: 8.5x13"
[23]: 8.5x11"
[24]: 11x17"
[0]: Postcard
The number of characters printed is: 80 characters/72 rows for continuous
form paper (10 x 12"), 80 characters/66 rows for continuous form paper (10 x
11"), 136 characters/72 rows for continuous form paper (15 x 12"), and 136
characters/66 rows for continuous form paper (15 x 11").
z
When a continuous form paper is selected for [Original Size], [Paper Position]
cannot be set.
z
When [Preset%] or [Fit to Cut Sheet] is selected for [Reduce/Enlarge], the machine
automatically calculates the magnification based on a combination of [Original
Size] and [Paper Size]. If the ratio, however, is outside the range of 45-210%, the
document will not be reduced/ enlarged, and will be printed at a scale of 100%.
When [2 Up] is selected, the machine automatically calculates the magnification
based on a combination of [Original Size] and 1/2 of [Paper Size].
z
The orientation set here is that of the document. It is not affected by the
orientation of paper loaded in the paper trays.
Orientation 19 Sets the orientation of paper.
[0](Default): Portrait
[1]: Landscape
Setting Item Item Number Value
Paper position 20 Sets the paper position.
[0](Default): Without cut sheet feeder (left)
[1]: With cut sheet feeder (center)
z
When [Without cut sheet feeder (left)] is specified and FF (line feed command) is
received, the machine skips the number of lines specified in VFU. When [With cut
sheet feeder (center)] is specified, the machine inserts a page break.
z
When a continuous form paper is selected for [Original Size], [Paper Position]
cannot be set.
Output quantity 8 Sets the number of copies to be printed.
[1 to 250] (Default: 1): 1-250 copies
z
When the output quantity is specified by a client, that number of copies is printed.
After printing, the number set on the control panel is overwritten with the number
newly specified. However, the number of copies specified from the LPD port will
not overwrite the number set on the control panel.
Setting Item Item
Number
Value