Replacing Consumables
83
Maintenance
3
* : The remaining page yield for copy/print jobs is applicable when A4 paper LEF ( ) is used. The value is an estimate and varies
depending on the conditions such as the content printed, dot coverage (area coverage), paper size, paper type, copy/print
density, output image type, and machine operating environment.
When replacing the waste toner container, clean the LED printhead with the supplied
cleaning bar to prevent inconsistencies in density or color in copies and prints.
z
Do not touch the gray-colored sponge part on the back side of the Waste Toner Container B. Otherwise, your
hands may get dirty with toner.
z
When you replace the waste toner container, toner may spill and soil the floor. We recommend laying paper
on the floor beforehand.
z
The use of waste toner containers not recommended by Fuji Xerox may degrade image quality and
performance. Use only waste toner containers recommended by Fuji Xerox.
z
When the
machine is i
n the Power
Saver mode,
exit the Power
Saver mode by pr
essing the
<Power S
aver>
button and the <Machine Status> button on the control panel before you replace the waste toner container.
z
When replacing the waste toner container, press the <Machine Status> button and check the current status
for the waste toner container even when the control panel is lit.
1
Make sure that the machine is not operating, and open the front cover.
2
Pull out the waste toner container slowly while holding its handle with one hand.
3
Prepare a new waste toner container out of a box.
To Next Page
Loading...
Need help?
General
