Job Assembly
121
Copy
3
Delete Outside/Delete Inside (Extracting/Deleting the selected area(s)
from the original)
This feature allows you to specify the area for extracting or deleting and then copy that.
The maximum number of area you can select is 3.
1 Select [Delete Outside/Delete
Inside].
2 Select any item.
3 Select [Original Orientation].
Off
Images are not extracted or deleted.
Delete Outside
Extracts the selected areas and copy them.
Delete Inside
Deletes the selected areas and copy them.
Area Settings
Displays the [Delete Outside/Delete Inside - Area X] screen. The maximum number of
areas you can select is 3.
Note • X shows an area number.
For more information, refer to "[Delete Outside / Delete Inside - Area X] screen" (P.122).
Target areas of originals
You can specify the side 1, side 2 or both sides to extract or delete areas in 2-sided
copies.
z
Both Sides
Targets both sides.
z
Side 1 Only
Targets side 1.
z
Side 2 Only
Targets side 2.
Original Orientation
Refer to"Original Orientation (Specify the Orientation of Loaded Documents)" (P.88).
To Next Page
Loading...
