Fuji Xerox Document Centre 1100

10 Setups
354
Setups
10
Scan-to-FTP/SMB Defaults
You can select the default protocol used for transfer from FTP, SMB, and SMB (UNC
format).
1 Select [Scan-to-FTP/SMB
Defaults].
2 Select [Change Settings].
3 Select the setting value.
4 Select [Save].
Scan Size Defaults
Set the original size shown in [Scan Size] in the [Scan Options] screen.
An original size is assigned to each of the eleven buttons other than [Auto Detect].
When frequently scanning nonstandard size originals, by presetting a nonstandard
size, scan it is not necessary to enter the original size each time a scan is made.
1 Select [Scan Size Defaults].
2 Select the item to be set or
changed, and select [Change
Settings].
Note • Select [ ] to display the
previous screen and select
[ ] to display the next screen.
3 Select the setting value.
4 Select [Save].
A/B Series Size
You can select from ten A and B series sizes.
Inch Size
You can select from twelve inch series sizes.