Fuji Xerox Document Centre 1100

4 Scan
142
Scan
4
Scan to FTP/SMB
You can convert scanned data to TIFF, DocuWorks, or PDF formats, and then use the
FTP or SMB protocols to send the data to a computer on the network. For information
about initializing data, refer to the following.
Note • For Document Centre 1100/900, this feature does not appear for some models. An optional
package is necessary. For more information, contact our Customer Support Center.
• For DocuCentre 9000 not equipped with scanner, scan features are not available.
• A shared folder saving scanned documents by computer side needs to be made before
scanning the document.You also need to configure the FTP service when using with FTP
protocol transmission. For information about how to setup from computer side, refer to the
manual provided with the operating systems. For information about the operating systems,
refer to "Scan Feature Specifications" (P.552).
Transfer Protocol.......................................................................................................................142
Address Book............................................................................................................................143
Specifying a Forwarding Destination .......................................................................................143
Output Color .............................................................................................................................144
Lighten/Darken .........................................................................................................................144
2 Sided Originals.......................................................................................................................144
Original Type ............................................................................................................................145
File Format................................................................................................................................145
1 Select [Scan to FTP/SMB] from the
[All Services] screen.
Note • If the [All Services] screen is
not shown, press the <All
Services> button.
• Fields displayed vary
depending on the [Transfer
Protocol].
• The screen at right is from
DocuCentre 9000.
2 Specify a Forward destination from
the [Basic Scanning] screen.
Transfer Protocol
Select [Transfer Protocol], and in the next screen, select either [FTP], [SMB], or [SMB
(UNC Format)] as a forwarding protocol. For information about each protocol, refer to
"Specifying a Forwarding Destination" (P.143).