Fuji Xerox Document Centre 1100

Changing the Size of Paper in Trays
279
Paper and Other Media
9
Changing the Size of Paper in Trays 6 to 7
Following describes how to change the paper size on trays 6 to 7.
Note • When changing the paper size to non-standard size loaded in trays 6 and 7, contact your
Customer Support Center. If doing so, it never returns to the original setting.
1 Pull out the tray towards you until it
stops.
Important • While the machine processes a job, do not pull the tray out that the job uses.
2 Remove any paper loaded on the tray.
3 Loose the screw on the right to
remove your side and the other side
guide.
4 Attach the guides according to the
hole of the paper size to change,
and tighten the screws.
5 Load and align the edge of the
paper against the right edge of the
tray with the side to be copied or
printed facing up.
Important • Do not load paper exceeding
the maximum fill line.Doing so
might cause paper jams or
machine trouble.
6 Push the tray in gently until it comes
to a stop.
Note • Affix the paper size label to the
front of the paper tray.
Warning
When pulling out the paper tray,
do it slowly. If pulled out with too
much force, the tray can hit and
injure your knees.
MAX