3 Copy
60
Copy
3
Operations while Copying
This section describes the operations that can be performed during copying. The
following are the available operations and their reference pages.
Stopping the Copy Job ................................................................................................................60
Changing the Quantity of Copies................................................................................................61
Interrupting the Copy Job ...........................................................................................................61
Stopping the Copy Job
To cancel copying, follow the procedure below.
1 Select [Stop] on the touch screen
or press the <Stop> button on the
control panel.
2 Select [Stop].
Note • You can also stop the copy job by pressing the <C> button or the <Clear All> button.
3 If the screen of step 1 does not
appear, press the <Job Status>
button.
4 Select the job to cancel, and then
select [Stop].
  
<Stop> button
<Job Status>
button
To Next Page
Loading...
Need help?
General
