16 Specifications
558
Specifications
16
Printable Area
The printable area is as follows.
Standard Printing Area
The standard area that can be printed leaves a margin of 4.1mm on all four edges of
the paper (for SRA3 (320 mm wide), a margin of 11.5 mm left and right). Note that the
actual printing area may vary depending on the printer (plotter) control language.
Extended Printing Area
If it is made a setup which extends a printing area, in a print, in :305 x 480mm and a
copy, it is printable in the range of :297x432mm at the maximum. However, a printing
improper area changes depending on paper sizes.
Note • To extend the print area, change the PCL print driver or the [Print Area] setting on the touch
screen.
For information on how to make print driver settings, refer to the online help for the print driver. For
more about the setting on the control panel, refer to "Print Area" (P.347).
When the paper
width is less than 12
inches
When the paper
width is 12 inches
When the paper
width is 12.6 inches
(SRA3 (320 mm
width))
Printer
Copy
To Next Page
Loading...
