Error Code
505
Problem Solving
15
016-757
[Cause] Password is incorrect.
[Remedy] Enter the correct password.
016-758
[Cause] No Permissions to use service.
[Remedy] Check with your Auditron Administrator.
016-759
[Cause] Maximum number of pages for this service has been
reached.
[Remedy] Check with your Auditron Administrator.
016-760
[Cause] An error occurred during PostScript processing.
[Remedy] Take one of the following actions.
z
Set [Print Mode] to [Speed Priority].
z
Increase PostScript memory.
For information about [Print Modes], refer to the print driver's online help.
For information about memory, refer to "Allocate Memory" (P.344).
016-761
[Cause] An error occurred during image processing.
[Remedy] Set the [Print Mode] to [Speed Priority] and instruct
printing again. If this does not remedy printing, print in the
Ensure Print mode.
016-762
[Cause] A print language not installed on the machine was
specified.
[Remedy] In [Specify Print Mode] under [Port Settings], specify a
print language.
016-764
[Cause] Could not connect to the SMTP server.
[Remedy] Contact the SMTP server administrator.
016-765
[Cause] Could not send e-mail as the hard disk on the SMTP
server was full.
[Remedy] Contact the SMTP server administrator.
016-766
[Cause] An error occurred on the SMTP server.
[Remedy] Contact the SMTP server administrator.
016-767
[Cause] Could not send e-mail as the e-mail address was wrong.
[Remedy] Check the e-mail address and transmit again.
016-768
[Cause] Could not connect to the SMTP server as the e-mail
address of the machine was incorrect.
[Remedy] Check the e-mail address of the machine.
016-769
[Cause] The SMTP server does not support confirmation of e-
mail distribution (DSN).
[Remedy] Send e-mail without setting confirmation of e-mail
distribution (DSN).
016-771
016-772
[Cause] Unable to retrieve scan data repository address from the
CentreWare scan service.
[Remedy] Check the DNS address. Or, define the scan data
repository address by its IP address.
016-773
[Cause] The IP address for the machine is not set properly.
[Remedy] Check the DHCP environment. Or, specify a fixed IP
address for the machine.
For information about Network Settings, refer to Network Administrator
Guide.
Error Code
Category
Cause and Remedy
CPSMO
To Next Page
Loading...
Need help?
General
