15 Problem Solving
530
Problem Solving
15
Paper jams at tri-fold output tray 2d and lever 2g
1 Make sure that the machine has
stopped, and then open the right
cover on the light finisher.
2 Pull out the tri-fold output tray 2d,
swing lever 2g, and remove the
jammed paper.
Note • If paper is torn, check for any
torn pieces of paper inside the
machine.
3 Return lever 2g to the original
position and push back the tri-fold
output tray 2d.
4 Close the Finisher right cover.
Note • A message will be displayed and the machine will not operate if the Staple Finisher's right
cover is even slightly open.
Paper jams at unit 4 and knob 4a
1 Make sure that the machine has
stopped, and then open the right
cover on the light finisher.
To Next Page
Loading...
Need help?
General
