16 Specifications
564
Specifications
16
Extended settings
Paper Size 2 Sets the paper size for printing.This setting is possible when the "Paper
tray" setting is "Auto" or "Tray 5 (Bypass)". The sizes that can be set are
only cut sheets.
[3] : A3
[4] : A4
[5] : A5
[14] : B4
[15] : B5
[21] : 8.5 × 14
[22] : 8.5 × 13
[23] : 8.5 × 11
[24] : 11 × 17
[0] : Postcard
Important • When one of the "Trays 1 to 4 and 6 to 7" is selected, the paper
loaded in the selected paper tray determines the paper size, and the
"Paper Size" setting is not possible.
Note • When "Reduce/Enlarge" is set to "Preset" or "Fit to Cut Sheet," then
the magnification is set automatically, depending on the combination
of original size and paper size. However, if the magnification would
be outside the range 45 - 250%, the original is not resized, and is at
actual size print.
When two-up mode is selected, the magnification is set automatically
from the combination of original size and one-half of the paper size.
Setting item
Item
number
Setting values
Paper position 20 Sets whether or not the CSF is installed.
[0] (Default): No CSF
[1] : With CSF
Note • When continuous forms are selected for "Original size," the "Paper
Position" setting cannot be made.
Number of
copies output
8 Sets the number of copies to be printed.
[1 to 250] (Default) :1to 250 sheets
Important • When a number of copies to be printed is specified by the client, this
setting is reflected in the printing.After printing, the setting on the
control panel is also changed to this setting.However, when the
number of copies is specified from the NetWare or lpd port, after
printing, the control panel setting is not changed.
Setting item
Item
number
Setting values
To Next Page
Loading...
Need help?
General
