5.2 Common Menus Setting 163
[IP Filter (IPv4)]
Note
• [IP Filter] can be set also on CentreWare Internet Services. For details, refer to "Controlling Data Reception by IP
Address" (P. 329).
• When the Secondary Ethernet Kit (optional) is installed, [IP Filter (IPv4) 1] and [IP Filter (IPv4) 2] are displayed.
[SNTP Settings]
Network/Port
IP Filter Settings
IP Filter Settings
IP Filter (IPv4)
IP Filter (IPv4)
IP Filter
IP Filter (IPv4)
IP Address
IP Address
No.1
No.1
IP Address
No.1
IP Mask
IP Address
No.10
No.10
IP Address
No.10
IP Mask
Setting Description
IP Filter Sets whether or not to restrict reception using IP addresses.
• [Off] (default)
•[On]
IP Address Registers IP addresses allowed through the filter for printing. Up to ten IP addresses
can be registered. Set the filter address for registered IP addresses. Enter the IP
address and filter address in the format: xxx.xxx.xxx.xxx.
For IP addresses, xxx can be any number between 0 and 255. (See *2 on P. 215.)
For example, when [IP Address] is set to 129.249.110.23 and [IP Mask] is set to
255.255.255.0, IP addresses 129.249.110.xxx are allowed to print. xxx can be any
number between 1 and 254.
Note
• Up to 25 IP addresses can be registered in CentreWare Internet Services.
Network/Port
SNTP Settings
SNTP Settings
NTP Synchronize
SNTP Settings
Connect Interval
SNTP Settings
NTP IP Address
Setting Description
NTP Synchronize Sets whether or not to synchronize the time of the printer's machine clock with that
of the NTP server.
• [Off] (default)
•[On]
To Next Page
Loading...
Need help?
General
