164 5 Control Panel Settings
[HTTP-SSL/TLS]
Note
• Set this when encrypting HTTP communication data using the SSL/TLS protocol. [HTTP-SSL/TLS] appears only
when a certificate is registered on the printer.
• For details on encrypting HTTP communication data and a server certificate required for the printer, refer to
"Configuring HTTP Communication Encryption Settings" (P. 342).
[IPSec Comm.]
Connect Interval Sets the interval used for connecting to the NTP server. Specify the value from 1 to
500 hours in 1 hour increments. (See *2 on P. 215.)
• [168 Hours] (default)
NTP IP Address Sets the IP address of the NTP server.
Enter the IP address in the format: xxx.xxx.xxx.xxx. For IP addresses, xxx can be any
number between 0 and 255. (See *2 on P. 215.)
• [000.000.000.000] (default)
Network/Port
HTTP-SSL/TLS
HTTP-SSL/TLS
Enablement
HTTP-SSL/TLS
Port Number
Setting Description
Enablement Sets whether or not to encrypt HTTP communication data using the SSL/TLS
protocol.
• [Disabled] (default)
Disables SSL/TLS communication.
•[Enabled]
Enables SSL/TLS communication.
Port Number Sets the port number from 1 to 65535. (See *2 on P. 215.)
• [443] (default)
Note
• Set only unique port numbers.
Network/Port
IPSec Comm.
Setting Description
IPSec Comm. Sets whether or not to encrypt data in packet units when sending data to your
printer from the computer over the network.
• [Disabled] (default)
•[Enabled]
Note
• This item can be used only when the OS is Windows Vista, Windows 7, Windows
Server 2008 R2.
• For information on how to set the menu items, see "Configuring IPSec for
Encryption" (P. 345).
Setting Description
To Next Page
Loading...
