5.2 Common Menus Setting 181
User Detail
Setup
Failed Access
Log
Sets whether or not to record failed authentication to [Error History Report]
when authentication fails for the preset number of times in 10 minutes. This
is to detect invalid accesses.
• [Off]
•[On] (default)
When [On] is specified, the number of authentication failures recorded
can be specified as a value from 1 to 600.
Note
• Authentication failures are only recorded in [Error History Report], and
access denials, as in "[Panel Settings]" (P. 166) are not recorded.
Save Remote
Account
Sets whether or not to save remote accounts.
• [Disabled] (default)
•[Enabled]
Note
• This item appears when HDD Extension Kit (optional) is installed and
[Remote Accounts] is selected for [Login Type].
Del Remote
Account
Deletes user information for remote authentication saved by setting [Save
Remote Account] to [Enabled].
Note
• This item appears only when HDD Extension Kit (optional) is installed,
while [Remote Accounts] is set in [Login Type].
Use of Smart
Card
Sets whether or not to use the smart card authentication.
• [Disabled] (default)
•[Enabled]
• [Enabled (PKI Only)]
Smart Card
Logout
Sets how to log out with the contactless smart card.
• [Via Control Panel] (default)
Logs out by operation on the Control Panel.
•[Remove Card]
Logs out when the smart card is removed.
Charge
Print
-
Sets charge printing that uses authenticated user information.
Note
• This item appears only when HDD Extension Kit (optional) is installed.
PJL Receive
Command
Reception of remote printing commands can be controlled by PJL
commands. When [Off] is set or no PJL command has arrived on the printer,
the [Receive Control] setting described later is used.
• [Off] (default)
•[On]
PJL Output
Command
Printing of remote print jobs can be controlled by PJL commands.
• [Off] (default)
•[On]
Setting Description
To Next Page
Loading...
