BX924 S4 Upgrade and Maintenance Manual 117
Hard disk drives / Solid state drives
Ê If applicable, remove the mezzanine carrier as described in chapter
"Mezzanine cards" on page 121.
Ê Remove the respective disk mounting kit from the mounting platform as
described in section "Removing HDD/SSD" on page 108.
V CAUTION!
Ensure that the drives are uniquely identified so that you can reinsert
them into their original locations after replacing the backplane.
Ê Remove the 4 screws from the mounting frame as described in section
"Removing SSD 0" on page 109 or "Removing HDD/SSD 1" on page 111.
Ê Remove the HDD/SSD from the mounting frame as described in section
"Removing SSD 0" on page 109 or "Removing HDD/SSD 1" on page 111.
6.6.3 Removing the SAS / PCH backplane
Figure 30: Removing the SAS / PCH backplane
Ê Loosen the two screws (see arrows) of the defective SAS / PCH backplane.
Ê Remove the defective SAS / PCH backplane from the mounting frame.
To Next Page
Loading...
