BX924 S4 Upgrade and Maintenance Manual 247
System board components
Figure 114: Mounting the TPM
Ê Connect the new TPM to the system board.
Ê Secure the TPM with the TPM screw (see arrow) using the TPM bit insert
(see figure 113 on page 246).
I Do not fasten the screw too firmly. Stop as soon as the head of the
screw lightly touches the TPM.
10.3.1.4 Concluding steps
Perform the following procedures to complete the task:
Ê Close the server blade as described in section "Closing the server blade" on
page 56.
Ê Reinstall and secure the server blade in the system unit as described in
section "Installing the server blade in the system unit" on page 57.
Ê If applicable, close the rack door as described in section "Closing the rack
door" on page 62.
Ê Enable TPM in the system board BIOS. Proceed as follows:
Ê Open a virtual console for your server blade as described in section
"Launching a video redirection to a server blade" on page 63.
To Next Page
Loading...
