BX924 S4 Upgrade and Maintenance Manual 185
Processors
9.2.4 Concluding steps
Perform the following procedures to complete the task:
Ê Install the processor heat sink onto the processor as described in section
"Installing processor heat sinks" on page 211.
Ê Close the server blade as described in section "Closing the server blade" on
page 56.
Ê Reinstall and secure the server blade in the system unit as described in
section "Installing the server blade in the system unit" on page 57.
Ê If applicable, close the rack door as described in section "Closing the rack
door" on page 62.
Ê If available, update the system board BIOS and the iRMC to the latest
version as described in section "Updating or recovering the system board
BIOS and iRMC" on page 73.
Ê Enable boot watchdog functionality as described in section "Enabling boot
watchdog functionality" on page 84.
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section "Enabling
BitLocker functionality" on page 91.
Ê Enable the replaced processor as described in section "Enabling replaced
components in the system BIOS" on page 85.
To Next Page
Loading...
