BX924 S4 Upgrade and Maintenance Manual 187
Processors
Ê Shut down the server blade as described in section "Shutting down the
server blade" on page 52.
Ê Remove the server blade from the system unit as described in section
"Removing the server blade from the system unit" on page 54.
Ê If necessary, remove the memory as described in section "Removing a
memory module" on page 165.
Ê Open the server blade as described in section "Opening the server blade"
on page 55.
Ê Remove the desired processor heat sink as described in section "Removing
processor heat sinks" on page 219.
9.3.3 Removing a processor
I This description applies to the following procedures:
– Removing CPU 2 from a dual-processor configuration
– Removing CPUs from a system board (see section "Removing
processors" on page 186)
Ê Remove the desired processor heat sink as described in section "Removing
processor heat sinks" on page 219.
To Next Page
Loading...
