BX924 S4 Upgrade and Maintenance Manual 213
Processors
9.5.3.1 Preparing the heat sink and processor
When installing a new heat sink
Figure 90: Heat sink with protective cover
Ê Remove the protective cover from the heat sink (see arrow).
V CAUTION!
Ensure not to touch the heat-conductive paste on the bottom of the
heat sink.
When reusing a heat sink
Ê Ensure that all residual thermal paste has been thoroughly cleaned off the
copper surface of the heat sink.
Ê Apply thermal paste to the processor surface as described in section
"Applying thermal paste" on page 222.
To Next Page
Loading...
