BX924 S4 Upgrade and Maintenance Manual 175
Processors
9.2.2 Preliminary steps
Before installing a processor, perform the following steps:
Ê Disable BitLocker functionality as described in section "Disabling BitLocker
functionality" on page 66.
Ê Disable boot watchdog functionality as described in section "Disabling boot
watchdog functionality" on page 67.
Ê If applicable, open the rack door as described in section "Opening the rack
door" on page 51.
Ê Locate the desired server blade as described in section "Locating the
defective server blade" on page 43.
Ê Shut down the server blade as described in section "Shutting down the
server blade" on page 52.
Ê Remove the server blade from the system unit as described in section
"Removing the server blade from the system unit" on page 54.
Ê Open the server blade as described in section "Opening the server blade"
on page 55.
Ê If CPU 2 has to be installed, remove the "dummy heat sink" (plastic SSD
holder) as described in section "Removing the "dummy heat sink" of CPU 2"
on page 220.
To Next Page
Loading...
