120 Upgrade and Maintenance Manual BX924 S4
Hard disk drives / Solid state drives
© cognitas. Gesellschft für Technik-Dokumentation mbH 2013 Pfad: C:\Programme\FCT\tim_app\tim_local\work\PICHOL\OBJ_DOKU-20565-001.fm
6.6.5 Concluding steps
Perform the following procedures to complete the task:
Ê Shift the drive into the connector on the mounting frame as described in
section "Installing SSD 0" on page 101 or "Installing HDD/SSD 1" on
page 103.
Ê Tighten the 4 screws to the mounting frame as described in "Installing
SSD 0" on page 101 or "Installing HDD/SSD 1" on page 103.
Ê Reinstall the HDD/SSD to their original mounting platforms as described in
section "Installing HDD/SSD" on page 99.
Ê If applicable, install the mezzanine carrier as described in chapter "Installing
mezzanine cards" on page 134.
Ê Close the server blade as described in section "Closing the server blade" on
page 56.
Ê Reinstall and secure the server blade in the system unit as described in
section "Installing the server blade in the system unit" on page 57.
Ê If applicable, close the rack door as described in section "Closing the rack
door" on page 62.
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section "Enabling
BitLocker functionality" on page 91.
To Next Page
Loading...
