BX924 S4 Upgrade and Maintenance Manual 221
Processors
9.5.6 Replacing processor heat sinks
9.5.6.1 Removing the processor heat sink
Ê Remove the processor heat sink as described in section "Removing
processor heat sinks" on page 219.
9.5.6.2 Applying thermal paste
Ê Apply thermal paste to the processor surface as described in section
"Applying thermal paste" on page 222.
9.5.6.3 Installing the processor heat sink
Ê Install the processor heat sink as described in sections "Preparing the heat
sink and processor" on page 213 and "Installing the heat sink for CPU 1" on
page 214.
9.5.7 Concluding steps
Perform the following procedures to complete the task:
Ê If memory modules have been removed, install the memory into their original
location as described in section "Installing a memory module" on page 161.
Ê Close the server blade as described in section "Closing the server blade" on
page 56.
Ê Reinstall and secure the server blade in the system unit as described in
section "Installing the server blade in the system unit" on page 57.
To Next Page
Loading...
