Fujitsu PRIMERGY BX924 S4 - Preliminary Steps

BX924 S4 Upgrade and Maintenance Manual 255
System board components
10.3.3.2 Preliminary steps
Before replacing the TPM, perform the following steps:
Ê Disable BitLocker functionality as described in section "Disabling BitLocker
functionality" on page 66.
Ê If applicable, open the rack door as described in section "Opening the rack
door" on page 51.
Ê Locate the desired server blade as described in section "Locating the
defective server blade" on page 43.
Ê Shut down the server blade as described in section "Shutting down the
server blade" on page 52.
Ê Remove the server blade from the system unit as described in section
"Removing the server blade from the system unit" on page 54.
Ê Open the server blade as described in section "Opening the server blade"
on page 55.
Ê Remove the system board as described in section "Removing the system
board" on page 266.