BX924 S4 Upgrade and Maintenance Manual 99
Hard disk drives / Solid state drives
6.3 Installing HDD/SSD
6.3.1 Required tools
● Preliminary and concluding steps: tool-less
● Installing a HDD/SSD:
– Phillips PH2 / (+) No. 2 screw driver
6.3.2 Preliminary steps
Before installing a HDD/SSD, perform the following steps:
Ê If applicable, open the rack door as described in section "Opening the rack
door" on page 51.
Ê Locate the desired server blade as described in section "Locating the
defective server blade" on page 43.
Ê Shut down the server blade as described in section "Shutting down the
server blade" on page 52.
Ê Remove the server blade from the system unit as described in section
"Removing the server blade from the system unit" on page 54.
Ê Open the server blade as described in section "Opening the server blade"
on page 55.
Upgrade and Repair Units (URU)
Average task duration: 15 minutes
To Next Page
Loading...
