Figure 55: Connecting the cables to the 4x 3.5-inch HDD backplane
▶
Connect the following cables to the HDD backplane:
1 Power cable
2 SAS/SATA cable, according to the length
3 SAS/SATA cable, according to the length
4 SAS/SATA cable, according to the length
5 SAS/SATA cable
6 SAS/SATA cable, according to the length
7 OOB cable
The SAS/SATA cable has five connectors (2-6).
For the cable plan, see "Appendix B" on page 427.
Concluding steps
▶
Insert all HDD modules, see "Installing a 3.5-inch HDD module" on
page 129.
Make sure that you reinstall the HDD module in the bay it was located
before the HDD backplane replacement.
▶
Insert all dummy modules, see "Installing a 3.5-inch dummy module" on
page 132.
▶
"Reassembling" on page 57.
Hard disk drive (HDD) / solid state disk (SSD)
RX2530 M6 Upgrade and Maintenance Manual 137
To Next Page
Loading...
