▶
"Disconnecting the power cord" on page 47
.
▶
"Getting access to the component" on page 48.
▶
"Removing the air duct 1 (top system board)" on page 68.
▶
"Removing the fan cage" on page 64.
Installing the second 8x 2.5-inch HDD/SSD backplane
▶
Insert the HDD backplane in a slight angle and position it on the pin on the
bottom of the chassis (see Figure 63).
▶
Fasten the three knurled screws.
Figure 71: Connecting cables to the second 8x 2.5-inch HDD backplane
▶
Connect the following cables (example with one SAS cable):
1 If applicable, OOB cable
2 SAS cable
3 Power cable
Hard disk drive (HDD) / solid state disk (SSD)
160 Upgrade and Maintenance Manual RX4770 M6
To Next Page
Loading...
