UCM6100 Series User Manual
Version 1.0.18.13
CONFERENCE ROOM
The UCM6100 supports conference room allowing multiple rooms used at the same time:
• UCM6102/6104 supports up to 3 conference rooms allowing up to 25 simultaneous PSTN or IP
participants.
• UCM6108/UCM6116 supports up to 6 conference rooms allowing up to 32 simultaneous PSTN or IP
participants.
The conference room configurations can be accessed under Web GUI→Call Features→Conference. In this
page, users could create, edit, view, invite, manage the participants and delete conference rooms. The
conference room status and conference call recordings (if recording is enabled) will be displayed in this web
page as well.
Conference Room Configurations
• Click on "Create New Conference Room" to add a new conference room.
• Click on to edit the conference room.
• Click on to delete the conference room.
Table 63: Conference Room Configuration Parameters
Configure the conference number for the users to dial into the conference.
Note: Up to 64 characters.
When configured, the users who would like to join the conference call must enter
this password before accessing the conference room.
Note:
• If "Public Mode" is enabled, the password is not required to join the conference
room thus this field is invalid.
• The password must be at least 4 characters.
Configure the password to join the conference room as administrator. Conference
administrator can manage the conference call via IVR (if "Enable Caller Menu" is
enabled) as well as invite other parties to join the conference by dialing "0"
(permission required from the invited party) or "1" (permission not required from
the invited party) during the conference call.
Note:
• If "Public Mode" is enabled, the password is not required to join the conference
room thus this field is invalid.
To Next Page
Loading...
Need help?
General
