Firmware Version 1.0.9.26
UCM6100 Series IP PBX User Manual
Configure the number of seconds to ring the user before the call is
forwarded to voicemail (voicemail is enabled) or hang up (voicemail is
disabled). If not specified, the default ring timeout is 60 seconds on the
UCM6100, which can be configured in the global ring timeout setting
under web GUI->Internal Options->IVR Prompt: General Preference. The
valid range is between 5 seconds and 600 seconds.
Note:
If the end point also has a ring timeout configured, the actual ring timeout
used is the shortest time set by either device.
Enable automatic recording for the calls using this extension. The default
setting is disabled. The recording files can be accessed under web
GUI->CDR->Recording Files.
If set to “Yes”, users can skip entering the password when making
outbound calls.
If set to “By Time”, users can skip entering the password when
making outbound calls during the selected time condition.
If set to “No”, users will be asked to enter the password when making
outbound calls.
Time Condition for Skip Trunk
Auth
If “Skip Trunk Auth” is set to “By Time”, select a time condition during
which users can skip entering password when making outbound calls.
Configure personal password when making outbound calls via trunk.
Table 45: FXS Extension Configuration Parameters - Specific Time
Click to add Time Condition to configure specific time for this extension.
BATCH ADD EXTENSIONS
BATCH ADD SIP EXTENSIONS
In order to add multiple SIP extensions, BATCH add can be used to create standardized SIP extension
accounts. However, unique extension user name can’t be set using BATCH add.
Under Web GUI->PBX->Basic/Call Routes->Extensions, click on "Batch Add Extensions"->"Batch Add
SIP Extensions".
To Next Page
Loading...
Need help?
General
