Firmware Version 1.0.9.26
UCM6100 Series IP PBX User Manual
ANNOUNCEMENTS CENTER
UCM6100 series supports Announcements Center feature starting from firmware version 1.0.9.26.
Announcements Center allows users to previously record and store voice message into UCM6100 with a
specified code. The users can also create group with specified extensions. When the code and the group
number are dialed together in the combination of code + group number, the specified voice message is
sent to all group members and only extensions in the group will hear the voice message.
Figure 148: Announcements Center
ANNOUNCEMENTS CENTER SETTINGS
Table 91: Announcements Center Settings
Configure a name for the newly created Announcements Center for
identify this announcement center.
Enter a code number for the custom prompt. This code will be used in
combination with the group number. For example, if the code is 55, and
group number is 666. The user can dial 55666 to send prompt 55 to all
members in group 666.
Note:
The combination number must not conflict with any number in the system
such as extension number or conference number.
This option is to set a custom prompt as an announcement to notify group
members. The file can be uploaded from page ‘Custom Prompt’. Click
‘Prompt’ to add additional record.
Configure the ring timeout for the group members. The default value is 30
seconds.
To Next Page
Loading...
Need help?
General
