Grandstream Networks UCM6102 User Manual

Firmware Version 1.0.9.26
UCM6100 Series IP PBX User Manual
Page 243 of 305
CALL FEATURES
The UCM6100 supports call recording, transfer, call forward, call park and other call features via feature
code. This section lists all the feature codes in the UCM6100 and describes how to use the call features.
FEATURE CODES
Table 75: UCM6100 Feature Codes
Feature Maps
Blind Transfer
 Default code: #1.
 Enter the code during active call. After hearing "Transfer", you
will hear dial tone. Enter the number to transfer to. Then the
user will be disconnected and transfer is completed.
 Options
Disable
Allow Caller: Enable the feature code on caller side only.
Allow Callee: Enable the feature code on callee side only.
Allow Both: Enable the feature code on both caller and callee.
Attended Transfer
 Default code: *2.
 Enter the code during active call. After hearing "Transfer", you
will hear the dial tone. Enter the number to transfer to and the
user will be connected to this number. Hang up the call to
complete the attended transfer.
 Options
Disable
Allow Caller: Enable the feature code on caller side only.
Allow Callee: Enable the feature code on callee side only.
Allow Both: Enable the feature code on both caller and callee.
Disconnect
 Default code: *0.
 Enter the code during active call. It will disconnect the call.
 Options
Disable
Allow Caller: Enable the feature code on caller side only.
Allow Callee: Enable the feature code on callee side only.
Allow Both: Enable the feature code on both caller and callee.

Grandstream Networks UCM6102 Specifications

General

Brand	Grandstream Networks
Model	UCM6102
Category	PBX
Language	English