Grandstream Networks UCM6102

Firmware Version 1.0.9.26
UCM6100 Series IP PBX User Manual
Page 174 of 305
 Click on "Blacklist" to configure blacklist for all inbound routes.
 Click on to edit the inbound route.
 Click on to delete the inbound route.
INBOUND RULE CONFIGURATIONS
Table 58: Inbound Rule Configuration Parameters
Trunks
Select the trunk to configure the inbound rule.
DID Pattern
 All patterns are prefixed with the "_".
 Special characters:
X: Any Digit from 0-9.
Z: Any Digit from 1-9.
N: Any Digit from 2-9.
".": Wildcard. Match one or more characters.
"!": Wildcard. Match zero or more characters immediately.
Example: [12345-9] - Any digit from 1 to 9.
 The pattern can be composed of two parts, divided by a ‘/’ character.
The first part is used to specify the dialed number the second part is
used to specify the caller ID and it is optional, if set it means only the
extension with the specific caller ID is allowed to call in or call out.
For example, patter '_2XXX/1234' means the only extension with the
caller ID '1234' is allowed to use this rule.
Privilege Level
Configure the privilege level for this inbound route.
Default Destination
Select the default destination for the inbound call.
 Extension
 Voicemail
 Conference Room
 Queue
 Ring Group
 Paging/Intercom
 Voicemail Group
 Fax
 DISA
 IVR
 Dial By Name
 External Number
 By DID
When "By DID" is used, the UCM6100 will look for the destination