Firmware Version 1.0.9.26
UCM6100 Series IP PBX User Manual
GROUP SETTINGS
Table 92: Group Settings
Configure a name for the newly created group to identify the group.
Configure the group number. The group number is used in combination
with the code. For example, if group number is 666, and code is 55. The
user can dial 55666 to send prompt 55 to all members in group 666.
Note:
The combination number must not conflict with any number in the system
such as extension number or conference number.
Announcements Center feature can be found under web UI-> PBX->Value-added Features->
Announcements Center. The following example demonstrates the usage of this feature.
1. Click to create new group.
2. Give a name to the newly created group.
3. Create a group number which is used with code to send voice message.
4. Select the extensions to be included in the group, who will receive the voice message.
Figure 149: Announcements Center Group Configuration
In this example, group “Test” has number 666. Extension 1000, 1001 and 1002 are in this group.
To Next Page
Loading...
Need help?
General
