EasyManua.ls Logo

Grandstream Networks UCM6102

Grandstream Networks UCM6102
308 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Firmware Version 1.0.9.26
UCM6100 Series IP PBX User Manual
Page 23 of 305
options for network port settings are added. [NETWORK SETTINGS]
Updated LDAP client configurations information.
Added sample Email settings. [EMAIL SETTINGS]
Added manual time settings. [TIME SETTINGS]
Added "Enable Pick Extension" and "Extension Segment" options for auto provisioning settings.
Changed one of the discovery method from "SIP MESSAGE (OPTIONS)" to "SIP MESSAGE
(NOTIFY)" in zero-config feature.
Added pickup group feature. [Table 75: UCM6100 Feature Codes]
Added PSTN detection instructions for "Auto Detect" and "Semi-auto Detect". [PSTN
DETECTION]
Added "Auth ID" option for SIP register trunk configuration. [Table 50: Create New SIP Trunk]
Added LDAP sync options for peer SIP trunk. [Table 50: Create New SIP Trunk]
Changed the default setting of outbound route "Privilege Level" from "Internal" to "International" to
avoid potential misconfiguration and security risk.
Added DISA and Fax to IVR key press event options. [Table 61: IVR Configuration Parameters]
Added "Min Message Time" option in voicemail settings. [Table 62: Voicemail Settings]
Added Fax setting samples. [FAX/T.38]
Added DISA support for inbound route and IVR.
Added Event List support to monitor local extensions and remote extensions. [BLF AND EVENT
LIST]
Added feature code *0 for "Disconnect". [Table 75: UCM6100 Feature Codes]
Added feature code *8 for "Pickup Extension" in pickup group feature. [Table 75: UCM6100
Feature Codes]
Added "Record Prompt" and "Custom Name of Pickup Group" options in internal options. [Table
76: Internal Options/General]
Added warning information for "Allow Guest Call" option to avoid potential security risk caused by
misconfiguration. [Table 82: IAX Settings/General]
Changed reset mode to two mode "User Data" and "All". [RESET AND REBOOT]
FIRMWARE VERSION 1.0.1.22
This is the initial version.

Table of Contents

Other manuals for Grandstream Networks UCM6102

Related product manuals