Firmware Version 1.0.9.26
UCM6100 Series IP PBX User Manual
PAGING AND INTERCOM GROUP
Paging and Intercom Group can be used to make an announcement over the speaker on a group of
phones. Targeted phones will answer immediately using speaker. The UCM6100 paging and intercom can
be used via feature code to a single extension or a paging/intercom group. This sections describes the
configuration of paging/intercom group under Web GUI->PBX->Call Features->Paging/Intercom.
CONFIGURE PAGING/INTERCOM GROUP
ï‚· Click on "Create New Paging/Intercom Group" to add paging/intercom group.
Figure 116: Paging/Intercom Group
Table 67: Paging/Intercom Group Configuration Parameters
Configure paging/intercom group name.
Configure the paging/intercom group extension.
Select "2-way Intercom" or "1-way Page".
This option is to set a custom prompt for a paging/intercom group to
announce to caller. Click on ‘Prompt’, it will direct to the page
PBX->Internal Options->Custom Prompt, where users could record
new prompt or upload prompt files.
Page/Intercom Group
Members
Select available users from the left side to the paging/intercom group
member list on the right.
To Next Page
Loading...
Need help?
General
